Simple tips to Hook Up a Water Line to an ice box Through the Sink

Simple tips to Hook Up a Water Line to an ice box Through the Sink

Related Articles

A ice box with a automatic ice maker and an integrated water dispenser does nothing at all should you not have water line to connect to it. Numerous domiciles have ice box water supply line set up during initial construction, but this particular feature wasn’t contained in the building that is original of some domiciles. It is possible to solve this with an ice manufacturer installation kit which allows you to definitely utilize the plumbing system underneath the sink. The kit gives you the desired components to connect up a water line to your fridge.

Find your water supply lines beneath your sink. You’ve probably three water supply lines underneath the sink; two lines link straight to the tap although the 3rd line connects towards the dishwasher. The valve attached to the right region of the faucet could be the water supply line that is cold. Turn the water that is cold the supply line clockwise to shut it.

Attach a drill that is 5/16-inch to your drill. Drill holes when you look at the base cabinet walls to route water line from under the sink into the back regarding the ice box. Drill as near into the wall that is back of case possible, so that you usually do not lose space for storing in the case.

Thread the water line, within the ice manufacturer installation kit, through the certain area behind the ice box to underneath the sink. Keep the water that is excess behind the ice box.

Switch on the water that is cold to drain any water kept into the supply line. Utilize pliers to untwist the faucet supply line from the water supply valve that is cold.

Wrap threads https://hookupwebsites.org/fastflirting-review/ regarding the water that is cold with 2 or 3 wraps of thread-seal tape. Twist the male end of the quick-tee adapter onto the valve. Wrap the thread that is female the alternative end for the adapter with thread-seal tape. Twist the supply that is faucet on the feminine end associated with the adapter.

Slip the compression nut that was included with the kit on the newly installed supply line. Ensure that the threads are dealing with the end associated with the line. Thread the ferrule through the kit on the brand new line.

Wrap the rest of the male threads regarding the quick-tee adapter with thread-seal tape. Insert the water that is new in to the opening from the tee. Slip the compression nut within the male threads and tighten up it regarding the adapter.

Fasten all three pea nuts in the quick-tee adapter with pliers or an adjustable wrench. Don’t twist the pea nuts too tight since this may damage the supply valve, the supply line in addition to adapter.

Put the conclusion associated with the water line you want to connect with the fridge as a 5-gallon bucket. Turn the water that is cold valve on underneath the sink. Allow a few gallons of water explain to you the line that is new get rid of the air. Turn from the supply line.

Slip the rest of the compression nut and ferrule throughout the refrigerator end of this brand new water line. Link the relative line towards the water line connector regarding the straight straight back associated with fridge.

Turn the supply line on yet again. Watch out for leaks at most of the connections. Tighten the connections slightly if a leak is seen by you. If tightening the text will not stop the drip, turn off water, take away the connector and include additional thread-seal tape before reconnecting water line.

Plug your fridge in to the wall surface. Coil the water that is excess behind the refrigerator. Drive the fridge contrary to the wall surface.